NP241 Cable Shifter - Single Lever

Looking for a shifting solution for you NP241?
Having trouble adjusting shifting linkage?

Look no further than the cable shifter for the NP241, made 100% in the USA.
304 stainless laser cut parts.
303 stainless CNC machined parts.
Upon check out, please specify which version of the NP241 you have to receive correct hardware.
Standard Cable length is 60". Only select 72" if you have a custom shifter position location that requires the extra cable run. Please note custom cable sizes are available in 1 foot increments. Please reach out if you need non standard length.

Due to the way this cable shifter is installed, with 180 degree loop, please be aware that the shift pattern is reversed from factory shift pattern. Please make shift knob shift pattern selection correctly. If your unique installation does not require a 180 degree loop, thus, shift cable is straight all the way to the transfer case, then OE shift pattern is used on the shift knob.

• Shift Lever - Flush Mount (pictured)
• USA Made cable
• Premium Shift Boot
• Black anodized aluminum shift knob with shift pattern
• Correct bracketry for your set up.